Appendix C
A-105
10. Enter UPGR4088
and press
ENTER
if the cable is connected to com port 1.
NOTE:
The DDF3088 uses com port 1.
A flashing cursor appears in the upper left corner of the screen.
NOTE:
If the cable is connected to a com port other than com port 1, do not enter
UPGR4088. Instead enter the following command (substituting the X for the
correct com port number) and press
ENTER
:
COMM /B9600 /COMX
Ensure that there is a space after COMM and after B9600
.
11. Disconnect power from the DDF4088.
12. Reconnect power to the DDF4088.
13. Press
ESCAPE
immediately after the displayed memory check has completed and
before the batch file finishes running.
A series of messages is displayed, including BAD OR MISSING (B:\CONFIG.SYS).
This is normal and no corrective actions are necessary. After several seconds, the B:\
prompt is displayed.
If the batch file does not run and the B:\ prompt is not displayed, the RS232 settings
may need to be reconfigured and steps 10 through 13 repeated. (For help in
reconfiguring the RS232 settings on a PC, press
F1
.)
IMPORTANT:
If the A: prompt is ever displayed, enter B
:
and press
ENTER
before
proceeding.
14. From the B:\ prompt enter DEL *.* and press
ENTER
.
A message is displayed indicating that all files in the current directory will be deleted.
15. Enter
Y
(for yes) for permission to delete the files and press
ENTER
.
16. Enter TRANSFER -R 4088.EXE
and press
ENTER
.
NOTE:
Ensure that there is a space after TRANSFER and after -R. (On a DDF3088,
the hyphen character is accessed by simultaneously pressing the
SHIFT
and
K
keys.)
The message RECEIVING 4088.EXE... is displayed indicating that the B: drive is
ready to receive the file. Do not wait for the file to be received, but go immediately to
the next step. The transfer may not occur and the program may lock up if too much
time elapses between keyboard entries. If this occurs, the PC may need to be restarted.
17. Press the
PgUp
key.
The following is displayed:
UPLOAD WHICH FILE:
To Next Page
Loading...
Need help?
General