7088-8000
-46
Change Scale Factor Password (Menu 48)
This menu is used to change the scale factor password.
The scale factor password is designed to protect the
scale factor from unauthorized or accidental changes.
The scale factor password may be enabled or disabled.
The flowmeter ships from the factory with the scale
factor password disabled.
NOTE:
In addition to the scale factor password, the
flowmeter utilizes a system password
(Menu 47) to protect all configuration data
other than the scale factor.
If the scale factor password is enabled, the flowmeter
requests the scale factor password whenever the user
attempts to change the scale factor (Menu 52).
To change or disable the scale factor password:
1. Access Menu 48:
2. Enter the new scale factor password and press
ENTER
.
NOTE:
To disable the system password function
(to allow the scale factor to be changed
without entering a password), enter
0 (zero) as the scale factor password. The
password function can be enabled again
by changing the password back to a non-
zero number.
The following is displayed:
3. Enter the old scale factor password and press
ENTER
.
If the old scale factor password was correctly
entered, the following is displayed:
If the old scale factor password was incorrectly
entered, the following is displayed:
New Sc Fact Passwrd?
?
Old Scale Password?
?
Scale Password
Accepted
Scale Password
*** Rejected ***
To Next Page
Loading...
Need help?
General