Main group Subgroup Function
6 Measured value higher than can be displayed on the scale.
7 Measured value cannot be displayed.
8 Measured value cannot be measured. Technical alarm
III: Metering status and capacity
9 No metering system available.
10 Metering is stopped (STOP).
11 Metering is paused.
12 No metering in progress.
13 Metering time bar when the maximum metering time is programmed.
IV: Notification area
14 Polarisation is in progress.
15 Check the water supply.
16 The power supply is disconnected.
17 The feed chemical storage tank is empty.
18 Overmetering. Overmetering has been detected.
19 Check the flow or flow volume.
20 The timer is active.
21 The sensor is not operating.
22 The sensor must be maintained and serviced.
23 The sensor signal is unstable and fluctuating.
Operating concept and operation
37
To Next Page
Loading...
