Promise Technology VessRAID 1740s User Manual

Chapter 5: Management with the CLU
173
Making Netsend Settings
By default, Netsend service is set to Manual and its normal status is Stopped.
To make Netsend service settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight Netsend and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Press Ctrl-A to save your settings.
To start, stop or restart the Netsend service, highlight Start, Stop, or Restart and
press Enter.
Managing Netsend Recipients
Note that the Messenger service must be running on the recipient PC in order to
receive reports.
Adding a recipient
To add a recipient:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
1. Highlight Netsend and press Enter.
2. Highlight Message Recipient and press Enter.
3. Highlight Create New Message Recipient and press Enter.
4. Type the recipient’s IP address into the field provided.
5. Highlight Message Event Severity Filter and press the spacebar to change
severity levels.
The selected level and all higher severity levels of severity will be reported.
Severity levels (from lowest to highest) are: Info, Warning, Minor, Major,
Critical, and Fatal.
6. Press Ctrl-A to save your settings.
Changing Recipient Settings
To change recipient settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.

Promise Technology VessRAID 1740s Specifications

General

Brand	Promise Technology
Model	VessRAID 1740s
Category	Network Storage Server
Language	English