Chapter 4: Management with WebPAM PROe
63
Managing the Network Connection
The network connection deals with the VessRAID’s Management Port.
• Making Management Port Settings (below)
Making Management Port Settings
When you log into WebPAM PROe over your network, you use the VessRAID’s
management port.
Before you change settings, please see “Choosing DHCP or a Static IP Address”
on page 24.
To make changes to the Management Port settings:
1. Click the Subsystem icon in Tree View.
2. Click the Administrative Tools icon.
3. Click the Network Management icon.
4. Click the Port Configuration link in Management View.
5. To enable DHCP, check the DHCP box.
When DHCP is NOT enabled, enter:
• Primary IP address
• Primary subnet mask
• Default gateway IP address
• Enter a primary DNS server IP address.
6. Click the Submit button.
To Next Page
Loading...