Chapter 9: Troubleshooting
263
Event Notification Response
When you choose Event Notification, WebPAM PROe sends popup and/or email
messages regarding its status. The messages you see depend on your
notification selection and what is currently happening in the VessRAID. See
“Setting-up User Event Subscriptions” on page 59.
The table below cites:
• Reported Events – Events that require you to take action
• Corrective Actions – The action you should take in response to the event
A list of event categories is shown below.
• Battery (page 263)
• Blowers (page 264)
• Cache (page 265)
• Controller (page 265)
• Disk Array (page 265)
• Drive Interface Controller
(page 266)
• Enclosure (page 266)
• Event Log (page 266)
• Host Interface Controller
(page 266)
• Logical Drive (page 267)
• Media Patrol (page 268)
• Online Capacity Expansion
(page 269)
• PDM (page 269)
• Physical Disk (page 270)
• PSU (Power Supply Units)
(page 271)
• RAID Level Migration (page 272)
• Rebuild (page 272)
• Redundancy Check (page 273)
• Resource (page 274)
• Spare Check (page 274)
• Spare Drives (page 274)
• SMART (page 274)
• Synchronization (page 274)
• System (VessRAID) (page 275)
• Transition (page 275)
• Watermark (page 275)
Reported Event Corrective Action
Battery
Battery temperature is
above the threshold
The battery is too hot. Verify proper airflow around
the through the VessRAID. If airflow is OK, replace
the battery. See page 212.
Battery temperature is
normal
Normal.
Battery capacity is below
the threshold
Battery is drained. Run battery reconditioning. See
page 90 (WebPAM PROe) or page 135 (CLU).
Battery capacity is normal Normal.