Promise Technology VessRAID 1740s User Manual

Managing SAS Connections
187
Automatic IP Settings
To make Management Port settings automatically:
1. Press the or button until the display says Management Port.
2. Press the button and the display says Link Status Up.
If it says Link Status Down, reconnect to the network before preceding.
3. Press the or button and the display says DHCP Disable.
4. Press the button to make a change.
5. Press the button to Enable.
6. Press the button to confirm.
The display shows the new IP address set by the DHCP server.
Managing SAS Connections
SAS connections deal with the VessRAID’s two host data ports.
• Viewing SAS Port Information (page 187)
• Making SAS Port Settings (page 188)
To add a SAS initiator, see “Adding an Initiator” on page 66 (WebPAM PROe) or
page 159 (CLU).
Viewing SAS Port Information
The SAS Controller has one SAS channel. The SAS channel has two ports.
See “Making Data and Management Connections” on page 17 for information
about how these ports are physically connected to the Host PC.
To view information about the SAS ports:
1. Press the or button until the display says SAS Management.
2. Press the button and the display says SAS Port Info.
3. Press the button again and the display says SAS Port 1.
• Press the button again to see SAS Port 1.
• Press button and the button to see SAS Port 1.
If it says Link Status Down, reconnect to the network before preceding.

Promise Technology VessRAID 1740s Specifications

General

Brand	Promise Technology
Model	VessRAID 1740s
Category	Network Storage Server
Language	English