PSI PP4050 XP - Page 164

Appendix A Programming Guide
A-9
A-2.1.3 List of Supported PJL Commands
PJL COMMAND
Description
@PJL COMMENT [”text”]
The COMMENT command is used for adding a
line of information or a comment within a set of
PJL commands.
@PJL JOB [NAME= ”text”]
Defines the name and pages of a PCL print job.
[START= #] [END = #]
NAME = file name (ASCII text)
START = first page, range 1 to 214783647
END = last page, range 1 to 214783647
@PJL EOJ [NAME=”job
The EOJ command marks the end of the job
name”]
which was started with the previous JOB
command. It resets the PJL Current
Environment to the User Default Environment.
The JOB and EOJ commands should always be
used in pairs. Do not use one without the other.
@PJL ENTER LANGUAGE
Supported personality options are
= personality
PCL , HEXDUMP
@PJL RESET
The RESET command resets the PJL Current
Environment variables to their User Default
Environment values (see Figure on page before
for a description of PJL Environments).
@PJL INITIALIZE
The INITIALIZE command resets the PJL
Current Environment and the User Default
Environment variables to their Factory Default
Environment values.
@PJL DEFAULT
The DEFAULT command sets the User Default
[LPARM : personality]
Environment value for a specified variable.
Variable = value
Personality : PCL, HEXDUMP
For supported variables and values see table:
A-2.1.4 PJL Variables and Values
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es