Appendix A Programming Guide
A-10
PJL COMMAND (cont.) Description
@PJL SET The SET command allows the user to change
[LPARM : personality] the value of PJL Current variables for the length
Variable = value of a PJL job, or until a PJL reset condition
returns the value to is default.
Personality : PCL, HEXDUMP
For supported variables and values see table:
A-2.1.4 PJL Variables and Values
@PJL RDYMSG ["text of Display a message in the 1 line of the printer´s
message
] operator panel
st
The message length is at max. 16 characters
The printer remains online
@PJL RDYMSG ["
] Clear the message on the printer´s operator
panel
@PJL OPMSG ["text of Display the message in the 1 line of the
message
] printer´s operator panel
st
The message length is at max. 16 characters
The printer gets off line
After prompting of this status by pushing the
offline/online button, the printer goes ONLINE
again
@PJL INQUIRE Requests the current value for an environment
[ LPARM : personality ] variable.
Variable personality = PCL, HEXDUMP
port =
For supported variables and values see table:
PJL Variables and Values
@PJL DINQUIRE Requests the default value for an environment
[ LPARM : personality ] variable.
Variable personality = PCL, HEXDUMP
port =
For supported variables and values see table:
PJL Variables and Values
Mantenimiento Periféricos Informáticos SL C/Canteras, 15 28860 Paracuellos de Jarama Tel: 00 34 917481604 WEB: https://mpi.com.es
To Next Page
Loading...