Page 145
P*521 – P*523 Pump 2
When Relay 2 is programmed as a Pump, these parameters contain the same
information as above for Pump 2.
P*531 – P*533 Pump 3
When Relay 3 is programmed as a Pump These parameters contain the same
information as above for Pump 3.
P*541 – P*543 Pump 4
When Relay 4 is programmed as a Pump These parameters contain the same
information as above for Pump 4.
P*551 – P*553 Pump 5
When Relay 5 is programmed as a Pump These parameters contain the same
information as above for Pump 5.
P*561 – P*563 Pump 6
When Relay 6 is programmed as a Pump These parameters contain the same
information as above for Pump 6.
Volume
When P1-100, P2-100 = 6 (Volume)
Your Ultra Twin provides a variety of volume calculation features, with 11
pre-programmed vessel shapes. See Vessel Shape (P1-600, P2-600) for
more information. For each vessel you will need to know the dimensions
(P1-601 to 603, P2-601 to 603) in Measurement Units (P*104) which are
required to calculate the volume (P1-604, P2-604) which will be displayed
in the selected Volume Units (P1-605, P2-605).
If your vessel shape does not correspond with any of the pre-programmed
vessel shapes, then you can use the universal calculations. For this you will
need a level/volume graph or chart provided by the vessel manufacturer or
you can create one based on the dimensions of the vessel. You can enter up
to 32 pairs of breakpoints, and the more you enter, the greater accuracy of
the volume calculation will be.
To Next Page
Loading...
