Page 183
P1-902 Echo Strength1
This parameter displays the most recent echo strength figure from the
transducer on Point 1, where a higher figure indicates a better returned echo.
P1-903 Average Noise1
This is the mean noise reading from the transducer on Point 1. It is measured
while the transducer is not firing, and gives an indication of the average
amount of electrical noise present on the cabling.
P1-904 Peak Noise1
This is the peak noise reading from the transducer on Point 1. It is measured
while the transducer is not firing, and gives an indication of the maximum
amount of electrical noise present on the cabling.
P1-905 Sensitivity
This parameter determines the sensitivity of the unit. Please consult Pulsar
for further information and assistance on changing the value of this
parameter.
P1-906 Side Clearance
This parameter is used to set the distance by which the DATEM trace will
“stand off” from around unwanted echoes such as obstructions. Please
consult Pulsar for further information and assistance on changing the value
of this parameter.
Transducer 2 Status
P2
P2-910 – P2-916 Transducer 2
These parameters contain the same information as detailed in Transducer 1
Status, for Transducer 2.
To Next Page
Loading...
