Page 192
Remote Alarm
P1 and P2
When a Modem is connected to, via the RS232 port, (Consult Pulsar or your
local distributor for further details), the following parameters are used to set
up the Ultra Twin so that when the level reaches a specific alarm point, as
determined by the setting of the relay(s) the unit will dial and connect to a
remote telephone number to provide details of the event.
P*145 Tel. No.1
This parameter is used to enter the number of ‘0’s that appear at the
beginning of the telephone number to be dialled that is to receive the
message.
No ‘0’s present at the beginning of the
telephone number to be dialled.
1 ‘0’ present at the beginning of the
telephone number to be dialled.
2 ‘0’s present at the beginning of the
telephone number to be dialled.
P*146 Tel. No2
This parameter is used to enter to enter the next 6 digits, following the ‘0’s,
of the telephone number to be dialled. If there are less then 6 digits
following the ‘0’s then just enter the digits required, if there are more than 6
digits following the ‘0’s then enter the first 6 digits and then proceed to
P*147 and enter the remaining digits.
P*147 Tel. No3
This parameter is used to enter any remaining digits of the telephone number
to be dialled after completion of P*145 and P*146 above.
Example
Telephone number to be dialled is: 0 1234 123456
P*145 Tel. No. 1 = 1(One ‘0’ at the beginning of the telephone number)
P*146 Tel. No. 2 = 123412 (The next 6 digits following the ‘0’s).
P*147 Tel. No. 3 = 3456 (Remaining digits of telephone number).
To Next Page
Loading...
