Page 25
Chapter 3 How To Use Your
Ultra Twin
Operating the Controls
Display
On the wallmount model there are two identical displays, by default, the
top display will provide information on the current mode of operation, and
status of the remote communication for point 1 (transducer 1), while the
bottom display provides the same information for point 2 (transducer 2).
In the case of the fascia model, while in the RUN mode, the single display
will provide information for point 1 (transducer 1) on the main display
line and the auxiliary display provides the same information for point 2
(transducer 2).
When in Program Mode the display of the fascia mount model can be
“toggled” by pressing to change from point 1 to point 2 to access
parameters on each point.
While in the Run Mode they displays will show the current level reading
and its units of measure, along with status messages with regards to the
Transducer, Echo reception and Fail Safe Mode. Additionally they can be
programmed independently to provide status messages on alarms, pumps
etc.
When in the Program mode the display is used to read information on the
Menu System, Point of Measurement, Parameter Number and parameter
details and values, which can be entered.
During Test Mode the display is used to monitor the simulated level. A
bargraph is also provided which will provide a visual reading of the level, in
percentage of span.
To Next Page
Loading...
