Page 160
Average Flow
P1 or P2
P1-863, P2-863 Average Flow
This parameter will display the Average Flow for the time period set in
Average Time (P1-864, P2-864). It is read only and cannot be changed.
P1-864, P2-864 Average Time
This parameter will set the time period over which the Average Flow
(P1-863, P2-863) is to be calculated before being displayed.
Display Parameters
Options
P1 or P2
P1-800, P2-800 Display Units
This parameter determines whether the reading displayed is in
Measurement Units (P*104), or as a percentage of span.
Display is in percentage of span
dependant on Mode (P1-100, P2-100).
P1-801, P2-801 Decimal Places
This parameter determines the number of decimal places on the reading
during run mode.
Minimum = 0 (No decimal places), Maximum 3 = (3 decimal Places)
Default = 2 (2 decimal Places)
P1-802, P2-802 Display Offset
The value of this parameter is added to the reading before it is displayed, in
Measurement Units (P*104).
It does not affect the relay setpoints or the mA output, only the reading on
the display.
You could use this feature if for example you wanted to reference the
reading to sea level, where you would enter the distance between Empty
Level (P1-105, P2-105) and sea level. If the empty level point is below sea
level, then enter a negative value.
To Next Page
Loading...
