Page 37
Chapter 4 Quick Set-up Guide
This quick set-up guide shows you how to get up and running in a few
minutes in just four easy steps after installing your Ultra Twin.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter this.
Choose Quick Setup
Now you need to go into the quick setup. You will see on the menu the
words ‘Quick Setup’, which is the first item on the menu system. By default
the Ultra Twin will always access point 1 menu system to change to point
2 menu press the hot key. Try pressing the two arrow keys to see some
more menu options, but return to Quick Setup, and press
This takes you to the common applications
parameter (P200).
This takes you to the common applications
parameters, and you will see some options appearing
on the display.
Note
If you have already setup a common application, then there will be a
number shown other than 0, and you will see messages showing
what the current setup is. If you want to reset this and start again,
press 0 (which will reset all the quick setup parameters), otherwise
pressing ENTER will allow you to edit the parameters that have been
set.
To Next Page
Loading...
