Pulsar ULTRA TWIN - Auxiliary

Page 163
Auxiliary
P1 or P2
P1-810, P2-810 Units
This parameter determines whether the selected units of measurement are
displayed on the auxiliary line of the display in run mode.
Option
Description
0 = No
Measurement units will not be displayed
1 = Yes (Default)
Measurement units will be displayed
P1-811, P2-811 Alarms Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when an alarm relay is switched
on or off. The message is in the form “Alarm High ON”, where the ‘High’ is
determined by the setting of the relay Alarm ID (P*212, 222, 232, 242,
252, 262).
Option
Description
0 = No (Default)
Alarm messages will not be displayed
1 = Yes
Alarm messages will be displayed
P1-812, P2-812 Pump Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a pump relay is switched
on or off. The message is in the form “General 1 ON”, where the number
displayed is the number of the relay.
Option
Description
0 = No (Default)
Pump messages will not be displayed
1 = Yes
Pump messages will be displayed
P1-813, P2-813 Control Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a control relay is switched
on or off. The message is in the form “Time ON”.
Option
Description
0 = No (Default)
Control messages will not be displayed
1 = Yes
Control messages will be displayed