Pulsar ULTRA TWIN - Page 172

Page 164
P1-814, P2-814 Miscellaneous Messages
This parameter determines whether notification messages are displayed on
the auxiliary line of the display in run mode when a miscellaneous relay is
switched on or off. The message is in the form “Clock ON”.
Option
Description
0 = No (Default)
Misc. messages will not be displayed
1 = Yes
Misc. messages will be displayed
P1-815, P2-815 Auxiliary Mode
The auxiliary display can be used to give additional information on
calculated values of a point(s) of measurement, as determined by P1-816,
P2-816 Auxiliary Source.
The information available to be displayed will be dependant on the selected
Mode P1-100, P2-100, and the options are as follows:
Option
Description
1 = Distance
Values related to distance will be displayed.
2 = Level (Default)
Values related to level will be displayed.
3 = Space
Values related to space will be displayed.
4 = Head
Values related to head will be displayed.
5 = Flow
Values related to flow will be displayed.
6 = Volume
Values related to volume will be displayed.
7 = Totalis (R)
Values related to totaliser(s) will be displayed.
P1-816, P2-816 Auxiliary Source
This parameter determines which point or points of measurement, dependent
on the selected Mode (P1-100 and P2-100), that the auxiliary display will
relate to and the options are as follows:
Option
Description
0 = Off (Default)
Auxiliary display not used to display values
1= Point 1
Displays Point 1 calculated values.
2= Point 2
Displays Point 2 calculated values.
3= Avg. 1 & 2
Displays calculated average values of Point 1 & 2.
4= Sum 1 + 2
Displays calculated sum values of Point 1 + 2.
5= Diff. 1 - 2
Displays calculated differential values of Point 1–2.