Page 28
How to Access Program Mode
To enter program mode, you simply enter the passcode, via the keypad,
followed by the ENTER key. The default passcode is 1997, so you would
press the following:
Note
There is a time-out period of 15 minutes when in program mode, after
which time run mode will be resumed if you do not press any keys.
Once you have entered the program mode the Ultra Twin will
automatically access point 1 menu system, and the top display will show
“Program Mode” in the Mode Status Line and “Quick Setup” in the
Auxiliary Display Line, in the case of the wallmount model, the bottom
display, point 2, will be blank. To change from one point to the other point’s
menu system press the hot key, whilst in any Main Menu heading, e.g.
Quick Setup, Application etc. and you will toggle between the two points
and their relevant menu systems.
To Next Page
Loading...
Need help?
General
