Page 29
Hot Keys
There are five hot keys on the keypad, which can be used to quickly access
common parameters for viewing only, while in Run Mode. Pressing the hot
key once will display the first parameter, then repeated pressing will display
the others, then the Ultra Twin reverts to Run Mode. In program mode, they
have different functions, the functions are shown below.
When application is Flow, view
non-resettable totaliser(s). View
and reset the resettable
totaliser(s).
When application is Pump, view
information on total pump
running hours, and individual
pump running hours.
Not used with Ultra Twin.
Displays echo confidence, echo
strength, H.A.L.L., average
noise, peak noise or
temperature.
Not used with Ultra Twin.
When application is Pump, view
total number of pump starts and
individual pump starts.
Reset parameter to default
setting.
Not used with Ultra Twin.
Dependant on application
displays Distance, Level, Space,
Head, Flow, Volume or rate of
change of level.
Toggle between Point 1 & 2
Main Menu System.
When programming relays
toggle relay setpoints
between Ultra Twin’s units
of measure and % of span.
Not used with Ultra Twin.
Takes you to the last
parameter edited, when you
first enter program mode.
Gives details of unit type,
software revision and serial
number.
To Next Page
Loading...
Need help?
General
