Pulsar ULTRA TWIN - Parameter Listing; Application Parameters; System Units; Operation

Page 104
Parameter Listing
This section describes, in detail, all parameters available in the Ultra Twin.
Any parameter can be reset to its default, by pressing the hot key, whilst
in program mode.
Application Parameters
System Units
P1 and P2
P*104 Measurement Units
This parameter sets the units you want to use for programming and display
Option
Description
1 = metres
All units of measure are METRES
2 = cm
All units of measure are CENTIMETRES
3 = mm
All units of measure are MILLIMETRES
4 = feet (Default)
All units of measure are FEET
5 = inches
All units of measure are INCHES
Operation
P1 or P2
P1-100, P2-100 Mode of Operation
This parameter sets the mode of operation, when in run mode, and can be set
to one of the following:
Option
Description
1= Distance (Default)
Display shows the distance from the
transducer face to the surface.
2= Level
Display shows how full the vessel is.
3= Space
Display shows how empty a vessel is.
4 = OCM Head
Display shows how high the head is.
5 = OCM Flow
Display shows the instantaneous flow.
6= Volume
Display shows volume of material in the
vessel.