Page 35
To read a parameter value, send the command
/Pxxxx where xxxx is the parameter you wish to read, and the Ultra Twin
will respond with the parameter value.
To set a parameter, send the command
/Pxxxx:yy where xxx is the parameter number, and yy is the value you wish
to set it to.
Other commands you can use are:
/DISTANCE* (shows current distance)
/LEVEL* (shows current level)
/SPACE* (shows current space)
/HEAD* (shows current OCM head)
/FLOW* (shows current OCM flow)
/TEMPERATURE* (shows current temperature)
/CURRENTOUT** (show the mA output value)
/TOTALISER* (show 10 day totaliser logs)
* add 1 for channel (point)1 or 2 for channel (point) 2.
** add 1 for mA Output 1 or 2 for mA Output 2
Please consult Pulsar Process Measurement or contact your local Pulsar
representative for further details and a full list of available commands.
To Next Page
Loading...
