Page 64
To set-up an application for a device contained in special, choose 3 for Flow
followed by 5 for Special. You then need to select the primary measuring
device for your application from the following available options: palmer
bowlus flume, H-flume or a V notch, other than BS3680.
For devices which do not match any of the above devices the application can
be setup using a universal flow calculation, to select this option choose 3
for Flow followed by 6 for universal. You then need to select the primary
measuring device for your application from the following available options:
linear flow or curved flow.
Once you have chosen your application you will be asked a series of
questions which are answered by choosing the appropriate option as detailed
in the flow chart below. Once all of the questions have been answered you
will be prompted to provide further information, as detailed in the tables
below, in order to complete the programming of the unit.
To Next Page
Loading...
