Pulsar ULTRA TWIN - Page 74

Page 66
Wait …..
Parameter
Default
Description
P101
Transducer
1 = dB Mach 3
Type of Transducer to be used.
P706
Volume Units
1 = Litres
Units of flow as on display and used
for calculations.
1=litres
3=cubic feet
5=US gallons
2 = cubic metres
4 = UK gallons
6 = Mil.USG
P707
Time Units
1 = per second
Units of time that volume units will
be displayed and calculated in.
1= units/sec.
3= units/hour
2= units/min.
4= units/day
P104
Measnt Units
4 = feet
Units used to enter dimensions, and
displayed where appropriate.
1 = metres
3 = millimetres
5 = inches
2 = centimetres
4 = feet
P105
Empty Level
7.956 feet
Distance from the face of the
transducer to the material at the
bottom of the measuring element.
P703
Minimum
Head
0.000 feet
Distance from empty point (P105) to
zero flow.
P704
Max Head
7.956 feet
Distance from zero flow to max
flow. It should be noted that any
change to P704 updates P106 Span
and vice versa.
P824
Totaliser
Allocation
1= Point 1
Enables the Totaliser to a specfic
point of flow measurement or a
combination of flow when both
points set to measure Flow. For full
list of options see P824 in Chapter 5
Parameter Guide.
P815
Aux Mode
2 = Level
Enables the Auxillary display line to
display additional information whilst
in RUN mode. For full list of options
see P815 in Chapter 5 Parameter
Guide.