7–Configuring FCoE in a Windows Environment
Driver Parameters
7-2 FE0254601-00 A
Spin-up Delay Time that the adapter port
waits before scanning the
channel for devices.
0 0–2
seconds
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Frame Size Maximum length of a Fibre
Channel frame created by the
adapter for encapsulation in
an Ethernet frame.
2,048 512, 1,024,
2,048
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Enable Hard
Loop ID
Enables or disables the
adapter hard loop ID on the
Fibre Channel bus. Enabling
this parameter may be neces-
sary on some bus configura-
tions when devices do not
appear.
Disabled Enabled, Dis-
abled
QConvergeConsole
GUI or QConverge-
Console CLI
Enable
Extended Log-
ging
Enables or disables the log-
ging of driver-detected events
that occur in the driver or the
Fibre Channel bus.
0 0—Disabled
1—Enabled
QConvergeConsole
GUI or QConverge-
Console CLI
Execution
Throttle
Maximum number of com-
mands that a port can exe-
cute at one time. When a port
reaches its execution throttle,
no new commands can exe-
cute until the current com-
mand execution is complete.
65,535 1–65,535
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Login Retry
Count
Number of times that the soft-
ware tries to log in to a
device.
8 0–255
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Port Down
Retry Count
Time to wait before reissuing
a command to a port that is
down.
30 0–255 seconds
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Link Down
Timeout
Time to wait for a link to come
up.
30 0–240 seconds
Fast!UTIL, QCon-
vergeConsole GUI,
or QConvergeCon-
sole CLI
Table 7-1. Driver Parameters
Parameter Description Default Range
Configuration
Method
To Next Page
Loading...
Need help?
General