Qlogic QConvergeConsole CLI 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-tp (Display Host Topology)
SN0054667-00 C 5-35
-tp
(Display Host Topology)
Use the -tp option to show the topology configuration of the host:
# qaucli -pr fc -tp | topology
Under Linux, this feature is disabled if you are using the IOCTL or sysfs (inbox)
driver.
-u
(Firmware Area Update/Save)
Use the -u option to update the firmware preload area of the adapter from a
DAT file or to save the current firmware preload area of the adapter to a DAT file.
To update the adapter firmware preload table, issue the following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) <file name>
To save the current adapter firmware preload table to a DAT file, issue the
following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) save <file name>
Where:
 <hba instance> is the adapter instance number of an adapter port.
 <hba wwpn> is the world wide port name of an adapter port.
 <file name> is the name of the firmware preload table DAT file.
-v
(Display Version)
To show the version number of the QConvergeConsole CLI utility, issue the
following command:
# qaucli -pr fc -v
NOTE:
This option is available only for QLE2562.
NOTE:
This option is valid only in noninteractive mode.

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English