Qlogic QConvergeConsole CLI 2400 Series - Iscsi

10–Converged Network Adapter Interactive Commands
Loopback Test
10-116 SN0054667-00 C
Configure Test Parameters
6. Loopback Test<port selection>2. FCoE3. Configure Test Parameters
From the Loopback Test menu, select the Configure Test Parameters option to
open a loopback test submenu with options to configure the data patterns, data
size, number of tests, test increments, error handling, and loopback type. For
details about these parameters, refer to Table 5-6.
For example:
Loopback Test
=======================================================
CNA : 1 Port: 2
SN : AFE1028C03899
ENode MacAddr : 00:0E:1E:04:95:EF
CNA Model : QLE8242
CNA Desc. : QLE8242 QLogic Pci Express to 10GbE Dual Channel CNA (FCoE)
FW Version :
WWPN : 21-00-00-0E-1E-04-95-EF
WWNN : 20-00-00-0E-1E-04-95-EF
Link : SFP not installed
=======================================================
1: Data Patterns
2: Data Size
3: Number Of Test(s)
4: Test Increment(s)
5: Abort On Error
6: Loopback Type
Start Diagnostics Test
6. Loopback Test<port selection>2. FCoE4. Start Diagnostics Test
From the Loopback Test menu, select the Start Diagnostics Test option to start
the loopback test.
iSCSI
4. Adapter Diagnostics1. Converged Network Adapter1. CNA Model6. Loopback Test<port selection>3. iSCSI
This option is currently not supported.