Qlogic QConvergeConsole CLI 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-m (View, Enable, or Disable LUNs)
5-24 SN0054667-00 C
-m
(View, Enable, or Disable LUNs)
Use the -m command to:
 View all selective LUNs for all adapter ports
 View an adapter’s selective LUN list
 View the current selective state of a LUN on a specific target
 Enable (select) a LUN on a specific target on a specific adapter
 Disable (deselect) a LUN on a specific target on a specific adapter
 Enable all LUNs on a specific target on a specific adapter
 Disable (deselect) all LUNs on a specific target on a specific adapter
 Enable (select) all LUNs of all targets on a specific adapter
 Disable (deselect) all LUNs of all targets on a specific adapter
For these commands:
To view all selective LUNs for all adapter ports, issue the following command:
# qaucli -pr fc -m all (view | info)
To view an adapter’s selective LUN list, issue the following command:
# qaucli -pr fc -m (<hba instance> | <hba wwpn> | all) (view |
info)
QConvergeConsole CLI shows the adapter’s enabled LUN list in the following
format:
<target wwnn> <target wwpn> <lun id>
NOTE:
 If the current driver setting is Bind by Port ID, this option is not available.
 Under Linux, if you use the IOCTL or sysfs (inbox) driver, this feature is
disabled.
 You must persistently bind the targets before configuring selective LUNs,
(link).
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
target wwnn = World wide node name of the target
target wwpn = World wide port name of the target
lun id = ID of the LUN

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English