Qlogic QConvergeConsole CLI 2400 Series - NIC Noninteractive Commands; NIC Command Format

SN0054667-00 C 4-1
4 NIC Noninteractive
Commands
This chapter describes the noninteractive NIC command format and parameters
of QConvergeConsole CLI.
Command Format
Noninteractive mode format includes the following command:
qaucli -pr nic [optional parameters] <command option> [positional
parameters]
or
qaucli -pr nic -switch [optional cna_port_instance]
Where switch is one of the following:
 -beacon (Enable/Disable Port Beacon)
 -c
 -cardreset
 -ch
 -d
 -ei
 -extloopback
 -flashsupport
 -g (Display General System Information)
 -h (Help), -?, ?
 -i (List All QLogic CNA Ports Detected)
 -icna (CNA Information)
 -idcbx (Display Port DCBX Information)
 -intloopback (Configure Test Parameters)
 -iset (Display Configured Port Settings)
 -link (Display Physical Link Status)
NOTE:
To view the help, issue the -h command.