Qlogic QConvergeConsole CLI 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-c (Show Parameter Settings)
SN0054667-00 C 5-7
-c
(Show Parameter Settings)
Use the -c command to show the parameter settings for all adapters in the
system:
# qaucli -pr fc -c [ <all> ]
To show the parameter settings for a specific adapter, issue the following
command:
# qaucli -pr fc -c (<hba instance> | <hba wwpn>)
Where:
-cna
(FCoE Utilities Menu for QLE81xx and QLE82xx Adapters)
Use the -cna command to work with converged network adapters (QLE81xx
and QLE82xx).
The -cna command line options use the following variables:
To view general information for the adapter, issue the following command:
qaucli -pr fc -cna <hba instance>|<hba wwpn> --geninfo
To view data center bridging exchange protocol settings, issue the following
command:
qaucli -pr fc -cna <hba instance>|<hba wwpn> --dcb --info
To update the message passing interface (MPI) configuration table on the adapter
from a file, issue the following command:
qaucli -pr fc -cna <hba instance>|<hba wwpn> --updatecfg
<mpi file>
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
hba instance = Adapter instance number of a converged network adapter port
hba wwpn = World wide port name of a converged network adapter port
mpi file = MPI configuration DAT file
--detail = View detailed format
--raw = View raw format
param name = Parameter name
param alias = Parameter alias
param value = Parameter value

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English