Qlogic QConvergeConsole CLI 2400 Series - Dtdspa (List Targets); (Duplicate a Discovered Target); (Duplicate a Persistent Target); (Login and Persist a Discovered Target)

6–iSCSI Noninteractive Commands
-dtdspa (List Targets)
6-8 SN0054667-00 C
-dtdspa
(List Targets)
To view discovered targets, including both persistent and nonpersistent, issue the
-dtdspa command as follows:
-dtdspa <hba_port_inst>
If the specified port instance has no targets assigned, the CLI returns an error.
-dtdupd
(Duplicate a Discovered Target)
To duplicate a discovered target that is not persistent, issue the -dtdupd
command as follows:
-dtupd <hba_port_inst> <target_instance>
To obtain the target instance, use the command “-dtdsp (Display Discovered
Targets)” on page 6-7.
A duplicate target is assigned a new iSCSI initiator ID (ISID) and can then be used
to create a redundant path.
-dtdupd
(Duplicate a Persistent Target)
To duplicate a discovered target that is persistent, issue the -dtdupd command
as follows:
-dtdupd <hba_port_inst> <target_id>
A duplicate target is assigned a new iSCSI initiator ID (ISID) and can then be used
to create a redundant path.
-dtli
(Login and Persist a Discovered Target)
To log in a specific discovered target, issue the -dtli command as follows:
-dtli <hba_port_inst> <target_instance>
To obtain the target instance, use the command “-dtdsp (Display Discovered
Targets)” on page 6-7.
-dtlia
(Login and Persist a Discovered Target)
To log in all discovered targets, issue the -dtlia command as follows:
-dtlia <hba_port_inst>