Qlogic QConvergeConsole CLI 2400 Series User Manual

7–NIC Partitioning (NPAR) Noninteractive Commands
Command Summary
7-2 SN0054667-00 C
Command Summary
This section lists and describes each NPAR command in alphabetic order,
followed by a command description.
-ainfo
(Get NPAR Adapter Information)
To get NPAR adapter information, issue the following command:
> qaucli -npar -ainfo <adapter_inst>
where

<adapter_inst> is the adapter number displayed by the -ia command.
-changepersonality
(Change Physical Function Personality)
To change the physical function's personality, issue the following command:
> qaucli -npar -changepersonality <func_inst> <personality>
where

<func_inst> is the physical function number displayed by the -if command.
 Specify one of the following for the <personality> parameter:
 Specify
nic to change the personality type to NIC.
 Specify
iscsi to change the personality type to iSCSI.
 Specify
fcoe to change the personality type to FCoE.
 Specify
disable to disable the function.
-ei
(Get NPAR Command Line Return Codes)
To get NPAR command line return codes, issue the following command:
> qaucli -npar -ei
-eswitchinfo
(Get NPAR eSwitch Information)
To get NPAR eSwitch information, issue the following command:
> qaucli -npar -eswitchinfo <port_inst>
where
 <port_inst> is the physical port number displayed by the -ip command.

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English