Qlogic QConvergeConsole CLI 2400 Series - (Configure Isns Settings); (Isns Settings); (List LUN Information)

6–iSCSI Noninteractive Commands
-isns (Configure iSNS Settings)
6-14 SN0054667-00 C
-isns
(Configure iSNS Settings)
To configure the iSNS settings for QLA4010 and QLA405x, issue the -isns
command as follows:
-isns <hba_port_inst
> [iSNS IP Address] [iSNSPORT <port_number>]
If you do not specify the [iSNS IP Address] parameter, the command disables
the iSNS client on the specified adapter port.
Issuing this command resets the adapter.
-isns6
(iSNS Settings)
To configure the iSNS settings for IPv6 (QLE406x and newer), issue the -isns6
command as follows:
-isns <hba_port_inst> [iSNS IPv6-or-IPv4 Address] [-iSNSPORT
<port_number>]
If you do not specify the [iSNS IPv6-or-IPv4 Address] parameter, this
command disables the iSNS client on the specified adapter port.
Issuing this command resets the adapter.
-l
(List LUN Information)
Use the -l command to view the following information about LUNs attached to
the selected target:
 Adapter/Target/LUN number
 Vendor name
 Product ID
 Product revision
 LUN size
You can view this information for a specific LUN or for all LUNs attached to the
selected target.
To list the LUN information, issue the -l command as follows:
-l <hba_port_inst> <Target ID [LUN ID]>
If you do not include the LUN ID parameter, all the LUNs on the specified target
are shown.