11–NIC Partitioning (NPAR) Interactive Commands
Setting Up NIC Partitions
11-4 SN0054667-00 C
4. Select option 1: NPAR Configuration to display the NPAR
Configuration menu, which provides the following options:
1: Bandwidth Configuration
2: Change PCI Function Personality
5. Configure the bandwidth settings to meet your system requirements.
6. For example, to change the bandwidth of the function 1 NIC partition:
a. Select option 1: Bandwidth Configuration
b. Select option 1: Function:1
c. Select option 1: Modify Minimum Bandwidth (Figure 11-5)
Figure 11-5. Selecting to Modify Minimum Bandwidth
d. At the prompt, enter the percent value of bandwidth you want
committed to the selected function.
e. Enter the percent value of bandwidth you want to limit the selected
function to.
To Next Page
Loading...
Need help?
General
