10–Converged Network Adapter Interactive Commands
Adapter Configuration
10-24 SN0054667-00 C
Adapter Configuration
2. Adapter Configuration1. CNA Configuration
From the main menu, select the Adapter Configuration option, and then select
the configuration type (CNA Configuration). The Converged Network Adapter
(CNA) Protocol Type Selection menu presents options for FCoE, iSCSI, and NIC
configuration. For example:
Adapter Type Configuration Selection
1: CNA Configuration
(p or 0: Previous Menu; m or 98: Main Menu; ex or 99: Quit)
Please Enter Selection: 1
Converged Network Adapter (CNA) Protocol Type Selection
1: CNA FCoE Configuration
2: CNA iSCSI Configuration
3: CNA NIC Configuration
CNA FCoE Configuration
2. Adapter Configuration1. CNA Configuration1. CNA FCoE Configuration
From the Converged Network Adapter (CNA) Protocol Type Selection menu,
select the CNA FCoE Configuration option to open the Converged Network
Adapter (CNA) FCoE Configuration menu with options to configure adapter
parameters, target persistent binding, boot devices, virtual ports, driver
parameters, and selective LUNs. Options to export a configuration and generate
reports are also available. For example:
Converged Network Adapter (CNA) FCoE Configuration
1: HBA Parameters
2: Target Persistent Binding
3: Boot Devices Configuration
4: Virtual Ports (NPIV)
5: Driver Parameters
6: Selective LUNs
7: Export (Save) Configuration
8: Generate Reports
To Next Page
Loading...
Need help?
General
