Qlogic QConvergeConsole CLI 2400 Series - (Display Physical Link Status)

4–NIC Noninteractive Commands
-link (Display Physical Link Status)
4-10 SN0054667-00 C
For example:
> qaucli -pr nic -iset 1
=== Configured Port Settings for 1. CNA Port Index ===
Header_Data_Split_Enable : off
IPv4_Large_Send_Offload_v1_Enable : on
IPv4_Large_Send_Offload_v2_Enable : on
IPv6_Large_Send_Offload_v2_Enable : on
IPv4_TCP_Checksum_Offload_Enable : RxTx
IPv6_TCP_Checksum_Offload_Enable : RxTx
IPv4_UDP_Checksum_Offload_Enable : RxTx
IPv6_UDP_Checksum_Offload_Enable : RxTx
Jumbo_Frames_MTU_9000_Enable_Rx : off
Jumbo_Frames_MTU_9000_Enable_Tx : off
LOCAL_Administered_Address_MAC : 00:c0:dd:12:0f:f4
MAC_Address_Alias : paul
Receive_Side_Scaling_Enable : on
Receive_Ring_Size : 0
Transmit_Ring_Size : 0
PromiscuousModeEnabled : off
-link
(Display Physical Link Status)
To view the status of the physical link, including the port speed, issue the -link
command as follows:
> qaucli -pr nic -link [cna_port_inst]
For example:
> qaucli -pr nic -link 1
=== Physical Link Status for 1. CNA Port Index ===
Link Status : Up
Port Speed : 10 Gbps