Qlogic QConvergeConsole CLI 2400 Series - Page 275

10–Converged Network Adapter Interactive Commands
CNA iSCSI Configuration
SN0054667-00 C 10-71
Add A Target
2. CNA iSCSI Configuration4. Target Configuration<port selection>6. Add A Target
Select the Add A Target option to add a target device. For example:
IPv6 Target? [off]:
TGT_iSCSI_Name [] :iqn.1992-04.com.emc:cx.apm00103600607.b2
TGT_Port [3260] :
TGT_TargetIPAddress [0.0.0.0] :192.168.1.11
Disable a Target
2. CNA iSCSI Configuration4. Target Configuration<port selection>7. Disable a Target
Select the Disable A Target option to disable a target device. For example:
Target ID: 3 hba_no: 1 IP: 192.168.1.11 Port: 3260 TGT Instance #: 3
ISCSI Name: iqn.1992-04.com.emc:cx.apm00103600607.b2
Alias: 0607.b2
State: Session Active
Target ID: 4 hba_no: 1 IP: 192.168.1.10 Port: 3260 TGT Instance #: 4
ISCSI Name: iqn.1992-04.com.emc:cx.apm00103600607.a2
Alias:0607.a2
State: Session Active
Enter a Target ID:3
Target disable complete.
Enable a Target
2. CNA iSCSI Configuration4. Target Configuration<port selection>8. Enable a Target
Select the Enable A Target option to enable a target device. For example:
Target ID: 3 hba_no: 1 IP: 192.168.1.11 Port: 3260 TGT Instance #: 3
ISCSI Name: iqn.1992-04.com.emc:cx.apm00103600607.b2
Alias: 0607.b2
State: No Connection
Target ID: 4 hba_no: 1 IP: 192.168.1.10 Port: 3260 TGT Instance #: 4
ISCSI Name: iqn.1992-04.com.emc:cx.apm00103600607.a2
Alias:0607.a2
State: Session Active
Enter a Target ID:3
Target enable complete.