Qlogic QConvergeConsole CLI 2400 Series - Page 302

10–Converged Network Adapter Interactive Commands
CNA NIC Configuration
10-98 SN0054667-00 C
Configure Team Parameters
3. CNA NIC Configuration4. Team Configuration4. Configure Team Parameters
From the Configure Teams Menu, select the Configure Team Parameters option
to configure team parameters. For example:
Team Index: 1 Team Description: [Default Vlan][Team 2]:QLogic Teaming Virtual
Adapter #3
Select Team Index : 1
Updating parameters ... Plese wait ...
VT_MODE 1=Fail Over; 2=Load Balanced; 3=Static; 4=Dynamic Team-Active;
5=Dynamic Team-Passive[Fail Over]:
IFP_Jumbo_Packet_Size (590 .. 9614)[1514]:
IFP_LSO_IPv4_V1 (0-Disabled 1-Enabled )[Enabled]:
IFP_LSO_IPv4_V2 (0-Disabled 1-Enabled )[Enabled]:
IFP_LSO_IPv6_V2 (0-Disabled 1-Enabled )[Enabled]:
IFP_Checksum_Offload_IPv4 (0-Disabled 1-TX Enabled 2-RX Enabled 3-RX and TX
Enabled )[RX and TX Enabled]:
IFP_UDP_Checksum_Offload_IPv4 (0-Disabled 1-TX Enabled 2-RX Enabled 3-RX and
TX Enabled )[RX and TX Enabled]:
IFP_TCP_Checksum_Offload_IPv4 (0-Disabled 1-TX Enabled 2-RX Enabled 3-RX and
TX Enabled )[RX and TX Enabled]:
IFP_TCP_Checksum_Offload_IPv6 (0-Disabled 1-TX Enabled 2-RX Enabled 3-RX and
TX Enabled )[RX and TX Enabled]:
IFP_UDP_Checksum_Offload_IPv6 (0-Disabled 1-TX Enabled 2-RX Enabled 3-RX and
TX Enabled )[RX and TX Enabled]:
IFP_Large_RECV_Offload (0-Disabled 1-Enabled )[Enabled]:
IFP_RSS (0-Disabled 1-Enabled )[Enabled]:
User_Assigned_Name [Team 2]:
Failback_Mode 1=No failover; 2=Failover to preffered port; 3=Best available
[Best available]:
Failback_Delay (in milliseconds)[3]:
Save configured values? (yes, no) [yes]:
Saving modified extended values ... Please wait ... About to save team config.
Please wait ...
Successfully saved extended parameters.
Successfully saved parameters.