SN0054667-00 C 11-1
11 NIC Partitioning (NPAR)
Interactive Commands
This chapter outlines the steps for setting up NIC partitioning (NPAR) using
QConvergeConsole CLI in interactive mode. The displayed commands apply to
both Linux and Windows operating systems.
For an overview of NPAR, refer to Appendix A. NPAR is supported by the QLogic
3200 Series Intelligent Ethernet Adapters, and 8200 Series Converged Network
Adapters
For information about non-interactive mode NPAR commands, refer to Chapter 7.
To Next Page
Loading...