QubicaAMF XLi EDGE Series - Page 155

QubicaAMF XLi EDGE Pinspotter
Section 4-6 Page 4.6-6 Rev. Date: 10/2016
4.6.2.5 PROBLEM: 1
st
ball - sweep goes down and after a time delay the
sweep runs and cleans off all the pins and comes back to the
guard position. The table does not come down.
Figure 4.6-5
START
NO
Reset overload.
Table drive
motor overload
tripped?
YES
Defective
chassis?
Replace chassis.
YES