Rain Bird Maxicom2 User Manual

To set up a weather source in Maxicom
2
, you must describe the weather source
properties to Maxicom
2
. This chapter describes how to set the properties that are
required to operate a weather source.
There are two ways to set weather source properties:
• You can set weather source properties using the Weather Source wizard, which
guides you through a series of steps in which all required properties are set.
The wizard presents each property to you, gives an explanation of the property,
and a default value. You can move forward or backward within the wizard, or
even cancel the wizard at any time. The Weather Source wizard runs
automatically when you select the New option from the Weather menu. If you
already have a weather source open, you can also run the wizard for the
currently active Weather Source window by selecting the Configure option from
the Weather menu.
• You can set weather source properties using the Weather Source Property Setup
dialog box without the wizard. The Weather Source Property Setup dialog box
contains more properties than the Weather Source wizard outlines for you.
Even if you use the Weather Source wizard to set weather source properties,
you will need to set some properties from the Weather Source Property Setup
dialog box.
Both ways to set weather source properties are described in this chapter.
Setting Weather Source Properties
5.1
Setting Weather
Source Properties
5

Rain Bird Maxicom2 Specifications

General

Brand	Rain Bird
Model	Maxicom2
Category	Control Systems
Language	English