Setting a FREEDOM Time Window
The FREEDOM Remote System allows you to send commands to Maxicom
2
via a
touch-tone telephone or radio and a special modem assigned to a specific serial
port on your computer. To avoid the possibility of the FREEDOM Remote System
inadvertently interfering with the schedules you set up in Maxicom
2
, you will
probably want to limit the time frame (window) during which the FREEDOM
System can send commands to Maxicom
2
.
To set a FREEDOM Time Window,
1
With the System Properties Setup dialog box open, select the FREEDOM tab.
The FREEDOM sheet comes to the front of the stack.
FREEDOM Sheet
2
To change the FREEDOM password, enter the password in the Password field.
If there is already a password in the field, replace it by typing over it. The
password must be alphanumeric (composed of letters and/or numbers) and
may be up to ten characters long.
Setting System Properties
3.10
To Next Page
Loading...
