Station — allows you to specify the CCU station for which you want
to set a runtime.
Sensor — allows you to specify what the schedule should do in the
event of certain conditions at sensors.
Skip — allows you to skip a group of instructions in the schedule
when certain conditions are met.
FLO WATCH Zone — allows you to set up FLO WATCH Zone
monitoring instructions.
Link — allows you to link two different schedules to one another so
that the execution of one (the master) causes the execution of the
other (the dependent).
Decoder — allows you to set an output decoder to either ON or OFF,
causing the device attached to the decoder to operate or stop
operating.
Pulse Count — allows you to define an event that will occur when a
pulse decoder reaches a specified number of counts. Possible events
include schedule stopping, irrigation turning off, lights turning on,
etc.
Time and Pause — allows you to specify a period of time delay for
the schedule.
Loop — allows you to identify a group of instructions that must be
repeated in a loop fashion, causing the same set of instructions to be
repeated over and over until a condition is met.
Comment — allows you to place a line of text in the schedule to
explain why the schedule is set up as it is.
Audit — allows you to check the schedule for errors and validates the
schedule against the configuration of the CCU.
Creating and Editing a Site Schedule
6.15
To see Tooltip information
about an icon, place the
cursor over the icon.
To Next Page
Loading...
Need help?
General
