Rapid 2005 - Page 9

LIST OF TABLES
Table 1: Recommended Torque Settings................................. 9
Table 2: 2005 Dimensions...................................................... 11
Table 3: 2005 Weights ........................................................... 12
Table 4: Motor Weights .......................................................... 12
Table 5: 2010, 2010B, 2020 and 2030 Dimensions ............... 13
Table 6: 2010, 2010B, 2020 and 2030 Weights ..................... 14
Table 7: Motor Weights .......................................................... 14
Table 8: 2000-Series Selection Guide.................................... 15
Table 9: Estimated Pressure Drop of Accessory
Components ............................................................. 16
Table 10: Minimum Recommended Duct Size ....................... 73
Table 11: Discharge Duct Size Recommendations to
Connect to Heater (for BD/RD)............................. 73
Table 12: Gas Manifold Size .................................................. 74
Table 13: Control Voltage Wiring For All Control Systems..... 78
Table 14: Full Load Current Draw .......................................... 79
Table 15: Safety Systems....................................................... 79
Table 16: Minimum and Maximum Fuse Size by Motor Size
and Supply Voltage............................................. 106
Table 17: Configuration Chart .............................................. 109
Table 18: Factory Preset Schedule on TH8110
Thermostat.......................................................... 112
Table 19: Site-Configuration Jumper Options ...................... 112
Table 20: Deflection Force B and BX Belts (in lbs) .............. 118
Table 21: Motor Sheave Drive Torque Specifications .......... 119
Table 22: Motor and Blower Bushing Torque
Specifications...................................................... 119
Table 23: Burner Mode by Amplifier Type............................ 121
Table 24: Maximum Temperature Rise ................................ 121
Table 25: Motor L
ubrication Intervals ................................... 127
Table 26: Burner Selections ................................................. 129
Table 27: Control Panel........................................................ 132
Table 28: Power Panel ......................................................... 133
Table 29: Manifold Components........................................... 134
Table 30: Blower .................................................................. 134
Table 31: Remote Panel....................................................... 135
Table 32: V-Belt.................................................................... 135
There are references in this manual to various trademarks. All trademarks mentioned herein, whether registered or not, are the
property of their respective owners. Rapid Engineering LLC is not sponsored by or affiliated with any of the trademark or registered
trademark owners, and makes no representations about them, their owners, their products or services.