Raytheon V8010 User Manual

ENTERWPTNO. If you want to store waypoint data into a particular memory
# , press the IENTER WPT #I softkey, type the desired Wpt memory # ( X,X,
X,), then press IENTER
Example: Press ~ENTERWPT#~,O,l,O,~ENTERj for Wpt.# 10.
If the letter ‘7J”appears below the Wpt # on the display, ‘U”signifies that
the Waypoint memory is being ‘Used” or already has Latitude/Longitude
coordinate data memorized into that Waypoint memory. If both the letters
“U” and ‘P” appear below the Waypoint # , the letters signify that this Wpt
memory is both “Used” (Lat/Long memorized) and the memory contents
are ‘Protected” (cannot be overwritten).
When a waypoint is “Protected”, the contents of the memory may not be
changed or overwritten until the protection feature is removed. You can
“protect” and ‘un-protect” your waypoints by following the procedure de-
scribed in the Waypoint List-SAVE function (see section 3.4.3.2.4) that
follows.
If the memory is protected, you can always enter a different memory
number or go to the waypoint list for a look at the available waypoint
memories.
WAYPoINT LIST Press this softkey to see a directory of the waypoint
memories.
When the WAYPoINT LIST page appears, use the A (up) / v (down)
direction keys (one at a time) to scroll through the memory listings in either
direction.
If the desired memory number is too far away
from the numbersdisplayed,just pressthdw[
key, followed by the number of the desired mem-
ory (X,X,X,). Then presslENTER] . The desired
memory will now become the selected location.
Example: To select memory number 023: Press
IGoTo/810,2,3,~
BRG DTG
+a”B orlr xz,,
If you want to store a new waypoint or edit the
existing information of a selected (highlighted)
PRESS MENU TO RETURN
OPERATION 83

Raytheon V8010 Specifications

General

Brand	Raytheon
Model	V8010
Category	Marine Equipment
Language	English