3.3.7.1 Navigation Operations
When you are using the Navigate-Position page you can perform any of
the same operations available in the Fishfinding, PlotBbmp, or Cruise
modes, as follows:
33.7.1.1 GOT0 a Selected Waypoint:
The message
‘WTo#
_
“appears in the message box along the
bott’om
of the screen when
thdqkey
is pressed. As the memory number is
entered, the digits are also seen in the message box When
the[akey
is pressed, the new
waypoint
information appears in the top row of the
Navigate-Position display.
33.7.l.2
Store an EVENT
Press
the-1
key when you are at the location to be saved. The
vessel’s present position will be stored into memories # 301-380and marked
on the plot as a square-shaped symbol.
(0)
The message ‘EVENT # XXX
SAVED”appears
in the message box along the bottom of the screen for your
reference.
3.3.7.l3
Route Following Operations
If you are following a route plan you may perform the following operations
to control the route plan:
To change to the next leg in the route
Press the
q
key, and then
To by-pass the next
waypoint
in a route:
Press the
q
key, and then
-1.
ADVANCE
BY-PASS
-I-O
WPl-
036
TYPICAL ROUTE OPERATIONS
OPERATION
73~