79
(3) [Delayed Stop] page
Sets trace stop conditions. It is possible to set trace stop conditions with and without delay, with both allowed
simultaneously.
Figure 5.32 [Trace Acquisition] Dialog Box ([Delayed Stop] Page)
[Stop With Delay]: Defines a trace stop condition.
[Enable]: Checking this box enables a trace stop.
[Delay Count]: Sets the delay count (in bus cycles, range 1 to 65535). This function allows
you to acquire a number of trace records after any of the specified events
occur.
[Events]: Lists the event points where trace acquisition conditions have been set. If the
box that corresponds to an event point is checked, trace acquisition will be
stopped when that event is satisfied (only available when [Enable] has been
selected).
To Next Page
Loading...
Need help?
General
