Controller Options
SM 2-83 D009/D011/D012/D013/D091/D092
Installation
1. Remove the slot cover [1] from the board slot ( x 2).
2. Install the wireless LAN board (Knob-screw x 2) into the board slot.
3. Make sure that the machine can recognize the option (see ‘Check All Connections’ at
the end of this section).
4. Peel off the double-sided tapes on the Velcro fasteners [2], and then attach them [2] at
the front left and rear right of the machine.
5. Attach the "ANT1" (having a black ferrite core) to the front left of the machine.
6. Attach the "ANT2" (having a white ferrite core) to the rear right of the machine.
"ANT1" is a transmission/reception antenna and "ANT2" is a reception
antenna. Do not attach them at the wrong places.
7. Attach the clamps as shown above.
8. Wire the cables and clamp them ( x 8).
To Next Page
Loading...
