Ricoh D009 - By-Pass; By-Pass Paper Size Sensor; When Reinstalling the By-Pass Paper Size Sensor

By-pass
D009/D011/D012/D013/D091/D092 4-78 SM
4.14 BY-PASS
4.14.1 BY-PASS PAPER SIZE SENSOR
1. Open the by-pass tray [A].
2. Move the side fences to the center.
3. By-pass tray cover [B] (
x 4)
4. By-pass paper size sensor [C] (
x 1)
When reinstalling the by-pass paper size sensor
1. Adjust the projection [E] of the left side fence bar (it must be centered).
2. Install the by-pass paper size sensor so that the hole [D] in this sensor faces the
projection [E] of the left side fence bar.
3. Reassemble the copier.
4. Plug in and turn on the main power switch.