Main Machine Installation
D009/D011/D012/D013/D091/D092 2-14 SM
Paper Trays
1. Open the 1st paper tray, and then press down on the right side of the lock switch to
unlock the side fences.
2. Press in on the sides of the fence release, and slide the side fences to the appropriate
mark for the paper size.
3. Pinch the sides of the end fence and move it to the appropriate mark for the paper size,
then load the paper.
4. Check the position of the stack.
Confirm that there is no gap between the stack and the side fences. If you see a
gap, adjust the position of the side fences.
5. Press down the lock to lock the side fences.
6. Repeat this procedure to load paper in the 2nd paper tray.
Initialize TD Sensor and Developer
1. Connect the main machine to the power outlet, switch on the main machine, and wait
for the fusing unit to warm up.
2. Enter Copy SP Mode.
3. Press SP Direct to highlight "SP Direct", enter 2801, and then press
.
4. When the message prompts you to enter the lot number of the developer, enter the
7-digit lot number, press [Yes], and then press [Execute] on the touch-panel. This
initializes the TD sensor.
The lot number is printed on the end of the developer package. Recording the
lot number could help troubleshoot problems later. If the lot number is
unavailable, enter any seven-digit number.
5. Press SP Direct to highlight "SP Direct" and enter 2805, press , and then press
"Execute" on the touch-panel. This initializes the developer.
6. Press "Exit" twice to return to the copy window.
To Next Page
Loading...
