Ricoh D009 - Service Program Mode Tables; Service Table Key

Service Program Mode
SM 5-3 D009/D011/D012/D013/D091/D092
Service
Tables
5.1.2 SERVICE PROGRAM MODE TABLES
Please note these general changes in this section:
 Group 8(Data Log 2) is a new group of counters.
 Along with the addition of Group 8, many of the Group 7 counters have been removed.
Service Table Key
Notation What it means
[range / default / step]
Example: [-9 to +9 / 0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
*
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
MS Monochrome Scanner Model: D009/D012
CS Color Scanner Model: D011/D013/D091/D092
DFU Denotes "Design or Factory Use". Do not change this value.
Japan only
The feature or item is for Japan only. Do not change this
value.
D009/D011 40 cpm: D009/D011
D012/D013 50 cpm: D012/D013
D091 D091
D092 D092
SSP This denotes a "Special Service Program" mode.